Feature Posts

Thursday, 22 February 2018

Picture Perfect Spinner Card- *Cased*

Hello my friends,

I'm baaaack! lol. Two posts in one morning, i'm on a roll, hehe.

I don't follow a lot of people because i like to get around doing my own thing, in craft, and in life. But these cards were so so cute and fun i had to try them.

When you tilt the card, the little hat spins around from one end to the other. It's so cool!

The original idea came from France Martin at Frenchie Stamps. This video is where i found these cards .Frenchies Card Here

France used the Barn Door framelits to make hers. I don't have that set yet so i used our Classic Label Punch. My measurements are also different to Frances.

This is my favourite one of the bunch. I looove the balloons, and adore the colour palette of it all. So darn eye catching and pretty.



You will cut out the hats from the Picture Perfect DSP. Yes it's some fussy cutting time! But trust me, it's not that hard with the hats.
You will also need to back your DSP with some card stock, you want that baby to be nice and sturdy.



I have backed another piece of card stock onto my dsp, then punched out my slider piece.


You can use a washer, i have none so i have used a 5 cent coin, Australian currency. Sitting that behind the open part, i pop a mini dimensional on. I would use another coin but i had none so i punched out 3, 3/4" circles, glued them together with tombow and popped that on the dimensional. Punch out 1, 1' circle and glue to the top of the 3 we just put on. Use a normal size dimensional <<< this is optional, and i only used it to make sure it went over the sentiment properly, to put on top of that, then put your hat on.

Run our foam adhesive sheets along the top, bottom, and above the top and bottom of where your slider cut out is. Then you put it all on top of your card base and you are done.

I hope you enjoy this card. I think it's super fun!
If i have forgotten anything, or you have any enquiries, please don't hesitate to contact me.

Hugs xx


No comments:

Post a Comment